Menu
Your Cart

TENSE HSR-02 Hydrophore Sequencing Relays

TENSE HSR-02 Hydrophore Sequencing Relays
TENSE HSR-02 Hydrophore Sequencing Relays
TENSE HSR-02 Hydrophore Sequencing Relays
Out Of Stock
TENSE HSR-02 Hydrophore Sequencing Relays
TENSE HSR-02 Hydrophore Sequencing Relays
TENSE HSR-02 Hydrophore Sequencing Relays

TENSE HSR-02 Hydrophore Sequencing Relays


General : 

Hydrophore Sequencing Relays have been designed as they

will start operating when needed and operate simultaneously

Hydrophore sequencing relays are designed to regulate the number of booster that should operate according to the pressure and to ensure that the booster operates in equal time.

2x Pressure Switch Inputs

2x Hydrophore Outputs

Usage of Device and Working Principle 

The hydrophore sequence is as follows: (H1) - (H2) - (H3) and (H1-H2) -

(H2-H3) - (H1-H3). It activates hydrophores at the same number with the

closed switches and keeps them operating during the "t" time. After the

"t" time is up, it engages the next hydrophore or the hydrophore group and

t continues in this way. It deactivates hydrophores at the same number

with the open switches.

 Note: Do not energize the inputs and outputs (P1, P2, P3)

of the pressure switch.

Maintenance :

Switch off the device and release from connections. Clean the trunk of device with a swab. Don’t use any conductor or chemical might damage the device. Make sure device works after cleaning

Warnings :

Please use the device according to the manual. Don’t use the device in wet. Include a switch and circuit breaker in the assembly. Put the switch and circuit breaker nearby the device, operator can reach easily. Mark the switch and circuit breaker as releasing connection for device

Tecnical Specifications:

 Operating Voltage(Un): 150-250V AC

Operating Frequency: 50/60 Hz

Operating Power: <6VA

Operating Temperature: -20°C.... +55°C

Time(t): 10minutes

Display: HSR-02=5 x led, HSR-03=7 x led

Connection Type: Terminal connection

Cable Diameter: 1.5mm²(HSR-02), 2.5mm²(HSR-03)

Number Hydrophore: 2(HSR-02) and 3(HSR-03)

Number Pressure Switch: 2(HSR-02) and 3(HSR-03)

Contact: 3A/250V AC (Resistive Load)

Operating Altitude: <2000meter

Mounting: Vertical assembled in the panel

or assembled on the din rail.


Downlaod PDF manual 




Write a review

Note: HTML is not translated!
Bad Good
TENSE HSR-02 Hydrophore Sequencing Relays
4,900.00DA
  • Stock: Out Of Stock
  • Model: HSR-02